Looking through the source code, you'd want to try the DR-435 driver first, as it seems to be the most similar. But it's not directly supported by CHIRP, so that's something you'll want to change Regarding cabling, the same wiki has an entry that states that the 3pin plug seems to be common among all Alinco radios. Not quite sure CHIRP does much but channel programming though, and I thus don't know whether "repeater data" programming is covered by it, but I'll leave that up to your experience! The fact that you can program your radio according to the official device manual to be in slave mode for cloning is also a good sign, along with the fact that the manual specifies pinout! In fact, CHIRP's alinco driver has a common DR-x35 base class, indicating that they expect x35 devices to be similar enough! That doesn't list the DR-635, but it does list the DR-135, DR-235 and DR-435, and that might be a good sign (but clearly not a guarantee, since the hardware might simply be different). Of course, the first place you'd look would be the CHIRP project page.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |